Steps to Make a Hemp Square Bead Necklace with Beads

You can string beads on a bit of hemp just like you'd with every other stringing material (thread or wire) to produce a Square Bead Necklace. However, integrating macramé knots to your design can make your handmade hemp necklace a lot more interesting. The half knot and square knot fully trust beads and may be used to create a 16- to 17-inch choker-style necklace that sits at the bottom of the neck.

1. Knotting and Beading

Cut two 100- to 150-inch measures of hemp string for that outdoors strands and something 25-inch period of hemp for that center strand. The general rule is perfect for the outdoors (knotting) strands to become roughly five occasions as lengthy because the middle (filler) strand which means you don't exhaust string. The center strand ought to be a couple of inches more than the size of necklace you need to make.

Contain the three hemp strands together and tie an overhand knot at the very top to carry them together.

Push your pin with the knot and pin the knot to the top card board. The card board holds your projects in position when you tie the knots to help make the necklace.

Repeat the square knot for roughly 1 inch, then string a bead around the middle strand and push up towards the knots. If you would like your beads evenly spread around the necklace, count the number of knots you've made and repeat that in between each bead.

Continue generating square knots, ensuring to drag the outdoors strands tightly for your first knot following the bead to carry it safely.

Repeat steps 8 and 9 until your necklace is 16 to 17 inches lengthy. Test the fit your neck to check on fit while you close to the finish.

2.Finishing

Untie the overhand knot around the beginning finish and trim the loose strands so they are even. Then twist and place the finishes in to the second cord finish. Squeeze the cord finish closed with pliers as before.

Trim the loose finishes adhering out the top cord finishes.

Twist open two jump rings and fix someone to each cord finish. Around the second finish, add some Square Bead Necklace clasp before closing the jump ring.